How To Fix Door Locks
Reinforced door frame
Front Door Safety Tips – three ways to stop intruders started kicking in the doors!
The FBI says a home is invaded every 12 seconds by someone who goes straight through a front or back entrance. Secure your doors. "
the best way for a person to destroy his house is just to put in the output. He is the way that most of the attackers and thieves house into a home. In fact, come right out the door more seventy percent of the time … and eighty percent of the time frame of the door does not lock the doors because most people believe.
So What someone kicked in the door? reinforced door frame
more often the doors are "shoulder Slammed 'or'Mule kicked" by intruders. "Shoulder Slamming" is just driving a shoulder on a door with great force. 'Kicking Mule' is when a person turns away from the door and kicked in the same way as a mule kick with his hind leg. a door "Kicking Mule 'is the favorite form of an intruder to access, allowing you to see who could be watched from the street and beyond, plus you can open a door in a split second when done in the right way.
The four reasons why doors can be kicked in so easily … reinforced door frame
1. Most door frames in the home are no less than two 2 "by 4" pine poles stuck together and covered with fine ornamental wood trim.
2. Most doorknobs and locks are secure in door.
three. Most door hinges are kept at the entrance and the door frame with screws around an inch long or less. (Go take a screw one of the hinges of your door and you see)
4. Most input frames are a little thin plate, which remains weak strike with the screws less than an inch long.
The way to correct the weak closure output and input Problems Marco …
realistically there is very little you can do to address the fact that its walls and door frames are made of softwood 2 "by 4" studs. It's just a fact that most houses are built in this way. But what can be done is to prepare all insignificant areas that are most likely to fail.
one. Put a safety gate metal on the areas where your gateway knob and bolt are extending to the edge of the door. This prevents the lock knob lock the door and come to have the ability to be broken from the door.
2. Replace the typical one inch short hinge screws 2.5 "long screws into the hinge side going to the door frame and put 1.5 'screws on the hinge that joins the gateway. This discourages the device side of the output of the possibility of being expelled.
3. Replace the small one to three inches of strike plates under the door with metal door five feet meat to the food as the gateway Security Guard Security Pro (available at: http://www.doorsecuritypro.com). This inhibits the latch side of the gateway to be able to be kicked open. This metal plate 5 "strike has a twofold purpose. Replace the puny strike plates with something much stronger and obstructs the door frames, wooden weak link Fractionation softwood. When the door frame is divided, that is what makes the knob and bolt to allow the door to open. Pro Security Gate also easily fix a damaged entry framework.
Output Knobs and Locks
except as noted above, be sure to have better doorknobs and locks quality, preferably newer'pick test 'models.
It makes little good to have fortified their framework and hinges entry if the quality of their locks is poor. For the same reason, good locks entry alone is not going to stop producing an entry, you may decide word and correct all the problems, if you will be absolutely protected.
reinforced door frame
The old saying … "An ounce of prevention is worth a pound of cure "most definitely applies when you think about your door frames and locks out. Please correct them now even though it is fresh in your brain. In fact, what is more valuable than your own safety, the safety of your family and home? security door
About the Author
David Carrington is a home security specialist. The time to protect your home and family is now. Don’t wait until it’s too late as so many others have. Visit Door Security Pro for more information.
Related posts:
